This is a working overview of secondary drying, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2025-07-14. Anything still debated is marked as such rather than presented as settled.
Quality control for freeze-dried lots combines visual inspection with instrumental tests. Cake appearance, color, and shrinkage are recorded against a reference, while residual moisture is measured by Karl Fischer titration or loss on drying. Thermal analysis can reveal phase transitions and crystallization events, and X-ray diffraction distinguishes amorphous from crystalline solids. Microbiological tests and container closure integrity checks are also routine for sterile products. Analytical methods must be validated for the matrix, because excipients and low moisture can affect accuracy. Open questions include how best to predict long-term stability from short-term data.
Lyophilized solids are often hygroscopic, so handling occurs in controlled low-humidity areas or glove boxes when the material is exposed. Vials remain sealed with elastomeric stoppers and aluminum crimps until use, because airborne moisture can raise residual water and shorten shelf life. The porous cake is fragile and may crack, shrink, or powder during transport. Personnel typically avoid repeated warming and cooling of sealed units, which can draw moisture through closures. These practices aim to preserve the low water content achieved during drying.
After primary drying, secondary drying removes water that remains bound to the material. This stage raises the shelf temperature while maintaining low pressure, which encourages desorption of unfrozen water. Residual moisture can be reduced to a low percentage, improving stability for many products. The process parameters, including freezing rate, shelf temperature, and chamber pressure, influence the final pore structure and reconstitution behavior. Control of these variables helps prevent collapse or meltback during drying.
A formulation often contains excipients that protect the active ingredient during freezing and drying. Bulking agents provide structure, while lyoprotectants stabilize sensitive molecules. The freezing step can produce ice crystals whose size and distribution affect the drying rate, and cycle design includes freezing, annealing, and drying phases. If the product temperature rises above a critical value, the cake may collapse or lose its porous structure. Successful lyophilization therefore depends on the interaction between formulation, equipment, and cycle design.
Lyophilization is a dehydration process that removes water from a frozen material by sublimation under low pressure. The material is first frozen to convert liquid water into ice. Next, the pressure is reduced below the triple point of water so that ice changes directly into vapor without passing through a liquid phase. This step is called primary drying. The result is a porous solid or cake that retains the original shape of the frozen solution.
| Property | Value | Notes |
|---|---|---|
| Typical storage temperature | 2–8 °C | Some products tolerate room temperature or require −20 °C. |
| Residual moisture method | Karl Fischer titration | Coulometric or volumetric; specific for water. |
| Cake appearance | Uniform porous plug | Collapse, shrinkage, or meltback indicates process deviation. |
| Reconstitution time | Seconds to several minutes | Depends on cake porosity, diluent, and formulation. |
| Primary container | Glass vial with elastomeric stopper | Crimp seal limits moisture ingress. |
Acta Biochimica et Biophysica Sinica was a Chinese-language journal entitled "Shengwu Huaxue Yu Shengwu Wuli Xuebao" (see box below), which began publishing sometime in 1958 or 1959, or August 1961, until December 2003 (depending on the source). Tables of contents were in English. Summaries (abstracts) were in English and Russian, and text of articles in Chinese. Later issues were promulgated in the Chinese and English languages. The translated title was "Journal of Biochemistry and Biophysics". The frequency was quarterly from 1959 to 1963, bimonthly from 1964 to 2002, and finally, monthly by 2003. Publication was suspended from 1966 to 1975. It was indexed in Chemical Abstracts Service. It may have published 35 volumes in total, over the years. In 2004 the journal switched to a full English-language journal under its current title. Official website Institute of Biochemistry and Cell Biology Archived 2003-12-17 at the Wayback Machine, SIBS, CAS
Although they are classically thought of working only together, GPCRs may signal through G-protein-independent mechanisms, and heterotrimeric G-proteins may play functional roles independent of GPCRs. GPCRs may signal independently through many proteins already mentioned for their roles in G-protein-dependent signaling such as β-arrs, GRKs, and Srcs. Such signaling has been shown to be physiologically relevant, for example, β-arrestin signaling mediated by the chemokine receptor CXCR3 was necessary for full efficacy chemotaxis of activated T cells. In addition, further scaffolding proteins involved in subcellular localization of GPCRs (e.g., PDZ-domain-containing proteins) may also act as signal transducers. Most often the effector is a member of the MAPK family.
Ancestim is a recombinant methionyl human stem cell factor, branded by Amgen as StemGen. It was developed by Amgen and sold to Biovitrium, now Swedish Orphan Biovitrum, in December, 2008. It is a 166 amino acid protein produced by E. coli bacteria into which a gene has been inserted for soluble human stem cell factor. It has a monomeric molecular weight of approximately 18,500 daltons and normally exists as a noncovalently associated dimer. The protein has an amino acid sequence that is identical to the natural sequence predicted from human DNA sequence analysis, except for the addition of an N-terminal methionine retained after expression in E. coli. Because Ancestim is produced in E. coli, it is nonglycosylated. Ancestim is supplied as a sterile, white, preservative-free, lyophilised powder for reconstitution and administration as a subcutaneous (SC) injection and is indicated for use in combination with filgrastim for mobilizing peripheral hematopoietic stem cells for later transplantation in certain cancer patients.
Division of analytical chemistry and laboratory of bio-electrochemical biosensor research function in this department. The division conducts research in the area of methods of electrochemical analysis using chemically modified electrodes and biosensors. The head of the department is Professor Gennady A. Evtyugin, doctor of Science in chemistry. The Department conducts research in the following fields:
Sources: en.wikipedia.org
There have been several structures solved for this class of enzymes, given PDB accession codes, and published in peer-reviewed journals. At least 4 such structures have been solved using pig enzymes: PDB: 1OHV, PDB: 1OHW, PDB: 1OHY, PDB: 1SF2, and at least 4 such structures have been solved in Escherichia coli: PDB: 1SFF, PDB: 1SZK, PDB: 1SZS, PDB: 1SZU. There are actually some differences between the enzyme structure for these organisms. E. coli enzymes of GABA-T lack an iron-sulfur cluster that is found in the pig model. Amino acid residues found in the active site of 4-aminobutyrate transaminase include Lys-329, which are found on each of the two subunits of the enzyme. This site will also bind with a pyridoxal 5'- phosphate co-enzyme. Aminooxyacetic acid Gabaculine Phenelzine Phenylethylidenehydrazine (PEH) Rosmarinic acid Valproic acid Vigabatrin 4-Aminobutyrate+Transaminase at the U.S. National Library of Medicine Medical Subject Headings (MeSH) Pearl PL, Parviz M, Hodgeman R, Gibson KM, Reimschisel T (2015). "GABA-transaminase deficiency". MedLink Neurology.
In molecular biology, the cyanobacterial clock proteins are the main circadian regulator in cyanobacteria. The cyanobacterial clock proteins comprise three proteins: KaiA, KaiB and KaiC. The kaiABC complex may act as a promoter-nonspecific transcription regulator that represses transcription, possibly by acting on the state of chromosome compaction. This complex is expressed from a KaiABC operon. In the complex, KaiA enhances the phosphorylation status of kaiC. In contrast, the presence of kaiB in the complex decreases the phosphorylation status of kaiC, suggesting that kaiB acts by antagonising the interaction between kaiA and kaiC. The activity of KaiA activates kaiBC expression, while KaiC represses it. Also in the KaiC family is RadA/Sms, a highly conserved eubacterial protein that shares sequence similarity with both RecA strand transferase and lon protease. The RadA/Sms family are probable ATP-dependent proteases involved in both DNA repair and degradation of proteins, peptides, glycopeptides. They are classified in as non-peptidase homologues and unassigned peptidases in MEROPS peptidase family S16 (lon protease family, clan SJ). RadA/Sms is involved in recombination and recombinational repair, most likely involving the stabilisation or processing of branched DNA molecules or blocked replication forks because of its genetic redundancy with RecG and RuvABC.
All the proteolytic activity of the asparagine peptide lyases is only self-cleavages, then no further peptidase activity occurs. The main residue of the active site is the asparagine and there are other residues involved in the catalytic mechanism, which are different between the different families of asparagine peptide lyases. The cleavage mechanism consists in the cyclization of the asparagine, assisted by other active site residues. In certain conditions, the asparagine cyclic structure nucleophilically attacks its C-terminal peptide bond to the main chain forming a new bond to create a stable succinimide, cleaving itself from the main chain and consequently releasing the two halves of the product. No inhibitors are known.
Sources: en.wikipedia.org
Ansuvimab was developed by the Vaccine Research Center with support of the United States National Institutes of Health and the Defense Advanced Projects Agency. The heavy and light chain sequences of ansuvimab mAb were cloned into CHO cell lines to enable large-scale production of antibody product for use in humans. In early 2018, a Phase 1 clinical trial of ansuvimab's safety, tolerability and pharmacokinetics was conducted by Dr. Martin Gaudinski within the Vaccine Research Center Clinical Trials Program that is led by Dr. Julie E. Ledgerwood. The study was performed in the United States at the NIH Clinical Center and tested single dose infusions of ansuvimab infused over 30 minutes. The study showed that ansuvimab was safe, had minimal side effects and had a half-life of 24 days. A license for ansuvimab was obtained by Ridgeback Biotherapeutics in 2018, from the National Institutes of Health-National Institute of Allergy and Infectious Diseases. Ansuvimab was given orphan drug status in May 2019 and March 2020.
Post-crash survivability is the chance that drivers and passengers survive a crash after it occurs. Technology such as Advanced Automatic Collision Notification can automatically place calls to emergency services and send information about a vehicle collision. Cars are much more dangerous to pedestrians than they are to drivers and passengers. Two-thirds of 1.3 million yearly auto related deaths are pedestrians. Since at least the early 1970s, attention has also been given to vehicle design regarding the safety of pedestrians in car-pedestrian collisions. Proposals in Europe would require cars sold there to have a minimum/maximum hood (bonnet) height. From 2006, the use of "bull bars", a fashion on 4x4s and SUVs, became illegal in the European Union, after having been banned on all new cars in 2002. Recent research has explored the use of multimodal sensor fusion to improve pedestrian detection in challenging conditions, including low-light environments and unusual pedestrian postures such as prone or fallen individuals.
The first automated insulin delivery system was known as the Biostator. Currently available AID systems fall into three broad classes based on their capabilities. The first systems released can only halt insulin delivery (predictive low glucose suspend) in response to already low or predicted low glucose. Hybrid Closed Loop systems can modulate delivery both up and down, although users still initiate insulin doses (boluses) for meals and typically "announce" or enter meal information. Fully Closed Loops require no manual insulin delivery actions or announcement for meals. A step forward from threshold suspend systems, predictive low glucose suspend (PLGS) systems use a mathematical model to extrapolate predicted future blood sugar levels based on recent past readings from a CGM. This allows the system to reduce or halt insulin delivery prior to a predicted hypoglycemic event.
Five amino acids possess a charge at neutral pH. Often these side chains appear at the surfaces on proteins to enable their solubility in water, and side chains with opposite charges form important electrostatic contacts called salt bridges that maintain structures within a single protein or between interfacing proteins. Many proteins bind metal into their structures specifically, and these interactions are commonly mediated by charged side chains such as aspartate, glutamate and histidine. Under certain conditions, each ion-forming group can be charged, forming double salts. The two negatively charged amino acids at neutral pH are aspartate (Asp, D) and glutamate (Glu, E). The anionic carboxylate groups behave as Brønsted bases in most circumstances. Enzymes in very low pH environments, like the aspartic protease pepsin in mammalian stomachs, may have catalytic aspartate or glutamate residues that act as Brønsted acids.
Sources: en.wikipedia.org
Karl Fischer titration is widely used because it is specific for water and works at low levels. Loss on drying is simpler but less specific, since volatile solvents or decomposition products can also be lost.
Collapse can occur when the product temperature exceeds its critical formulation temperature during drying. The porous structure then melts or shrinks, reducing reconstitution speed and sometimes altering stability.
No. Low moisture slows many degradation pathways but does not stop oxidation, hydrolysis, or physical changes completely. Storage temperature, container closure, and formulation still influence shelf life.
Lyophilization removes water by sublimation from a frozen material, while evaporation changes liquid water into vapor. The low-pressure freezing step avoids the liquid phase and can preserve heat-sensitive structures.